Gear repair agent manufacturers teach you how to repair diesel gear

Of course, we can use the gear repair agent to repair it as follows:
Reversing method: For one-sided wear of the gear surface, if the structure permits, the gear can be changed position or turned 180 degrees, and the unworn side is used, but it is better to use it in pairs, or replace the gear with the new one. To ensure that the gears mesh properly.
Insert ring method: The tower gear is composed of several gears, and the damage degree of each gear is different. If the gear teeth of individual gears wear, it can be repaired by replacing the ring gear. First, you need to repair all the gear teeth on the lathe, and make a ring gear to press on the car to the gear teeth. In order to prevent the new ring gear from loosening, it can be welded by spot welding at the joint of the ring gear and the gear, or by drilling the stud into the stud.
Inserting method: For gears with low load and low speed, after the individual teeth of the electric shovel toothing are knocked off, the root of the bad gear is cut out on the planer to fix the groove with a certain tightness. The same new tooth is pressed in, welded and processed.
Surfacing method: When the gears are worn by individual or several teeth or the wear on both sides of the tooth ends exceeds the limit, one or several layers of metal may be deposited on all or part of the surface of the gear according to the damage of the gear. Welding repair of gears can be divided into electric welding and gas welding. Surfacing repairs the gears, the operation is simple, and the repair quality is good.
Screw toothing method: Remove the worn and worn gears, clean them, measure the root thickness with a vernier caliper, and flatten and clean the toothed parts with a file. According to the thickness of the root, the screw of the corresponding diameter is selected, and the length of the thread is not shorter than 1.5 to 2 cm. Then use a bench drill to drill a hole of the same diameter as the screw at the gear drop and tap it with a tap. Screw the screw into the screw hole, then use a hacksaw to saw the screw that is higher than the top of the tooth, and then use a file to machine the same tooth as the original tooth.